Stainless steel pushrod tube
2V models from 9/75 (not R45/R65)
...
Piston ring set
R100 models
Only for modells with nikasil...
Duplex timing chain with chain link
/5 to /7 models
Duplex...
Simplex timing chain
From /7 models all 2V boxers
Simplex...
Chain guide rail for chain tensioner Simplex
for all 2-valve boxer...
Stainless steel pushrod tube
for R2V models up to 9/1975
...
Simplexチェーンテンショナー
適合車種: 2バルブボクサーモデル 9/1978-*
...
Tool for pushrod protection tube 18mm
2V models from 9/75
...
Piston for chain tensioner Simplex
for all 2-valve boxer models...
Simplex チェーン テンショナー用スプリング
適合車種: 2バルブボクサーモデル...
Spring for chain tensioner Duplex
for all /5, /6, /7 models until...
Duplex timing chain link
/5 to /7 models
Duplex timing chain...
Tool for pushrod protection tube 16mm
2V models to 9/75
...
Chain tensioner Duplex
for all /5, /6, /7 models until 9/1978
...
Timing Plug. Black rubber.
Replacement timing plug in original...
After some time, the control loop should be replaced. If this will be failed, the chain can jump over and a serious damage to the engine is a consequence. When a chain has to be changed, is depending on the type of the chain (simplex / duplex) and of its use and care. At our house you get duplex control loops with lock for R2V models up to 9/1978 and simplex control loops with lock for R2V models from 9/1978 as well as the suitable slide rail for the chain tensioner simplex. You can find chain tensioners in this category with spring or piston for simplex chains from 9/1978 and duplex chains up to 9/1978. If you determine an oil loss on the motorcycle, this might have something to do with leaking protective sleeves. We have protective sleeves made of stainless steel and the suitable punching pin for protective sleeves in the degrees 16 mm for R2V models up to 9/1974 and 18 mm for R2V models up to 9/1975. 16 mm punching pins were used until 9/1975. For R100 models with nicasil coated cylinders, we have also a piston ring set in our range.